Table of Contents
Advertisement
3.2 Adjusting Bengal To Its Source
3.2.4 Adjusting to Video Sources
Video adjustments are quite a bit like the controls on a television receiver.
Adjusting the picture
1. Select a video source in the Picture menu. There
is one composite video, one component input and
one S-Video source available.
2. Press
on the remote.
PICTURE
Now you have two choices.
• Adjust using any picture from the video source.
• Adjust using a standard color bar pattern from the
source.
Adjusting with any picture
This procedure must be done after you adjust color
balance (page 38).
1. Choose pictures that have blacks and whites rep-
resented as well as a variety of colors.
2. Adjust Contrast, Brightness, Saturation and Hue
on one Bengal until it looks satisfactory.
3. Adjust any other Bengal's so they have the same
values for Contrast, Brightness, Saturation and
Hue as the first Bengal.
Adjusting with color bars
1. If possible, use a color bar pattern from the video
source you will use for the program material. You
cannot use the color bar from the Test Patterns
menu.
2. In the Picture menu, check Blue Only. You should
see only the alternate color bars, all of them blue.
3. Adjust Saturation to make the outer two color
bars match. Match them in brightness; they will
already match in color.
4. Adjust Hue to make the inner two color bars
match.
5. Uncheck Blue Only.
.
When a video source is selected, Auto Setup Options is
not available. Adjustments must be made manually.
34
6. If the color bar pattern has a pluge, you can use it
to adjust Brightness.
Adjust Brightness so you can-
not see the difference between
these two marks, but you can
see the difference between
these two marks.
Pluge
Advertisement
Table of Contents
