ELECTROCOMPANIET EMP Owner's Manual page 26

Setup Menu -
30. Setting the HDMI audio
If you are not using the HDMI audio output,
you should set this to [Off]. If the
monitor/receiver connected to this player
using HDMI does not support HDMI audio
signal input, set this to [Off].
In'AUDIO SETUP PAGE", press▲▼ to
highlight [HDMI AUDIO], then press OK.
Notes:
• Super Audio CD signals cannot be
output using HDMI.
• This player can output following audio
signals using HDMI: 32/44.1/48 kHz.
2ch linear PCM signals and bit stream
signals {Dolby Digital, DTS and
MPEG).
• When audio signals are being output by
HDMI-compatible components, digital
output signals are muted.
ON
Select this to turn on the HDMI audio
output
OFF
Select this to turn off the HDMI audio
output
Speaker Setup
This menu contains setup options for
audio output so that you can set your
speakers to reproduce high quality sur
round sound. For details, see page 13.
CD upsampling info
This feature allows you to convert your
music CD to a higher sampling rate using
sophisticated digital signal processing for
better sound quality. If you have
activated the upsampling function, the
player will automatically switch to stereo
mode.
Audio
CD Upsampling
1 In AUDIO SETUPPAGE press ▲▼ to
highlight [CD UPSAMPLING], then
press OK
OFF
Select this to disable CD-upsampling.
88.2 kHz (X2)
Select this to convert the sampling rate of
CDs to twice that of the original.
176.4 kHz (X4)
Select this to convert the sampling rate of
CDs to four times that of the original.
2 Press AT to select a setting, then press
ENTER/OK to confirm your selection.
Note:
This setting is only valid for signals
output from the analog jacks.
Night Mode
In this mode, high volume output is softened
and low volume output brought upward to an
audible level. It is useful for watching your
favorite action movie without disturbing
others at night.
1 In AUDIOSETUP PAGE press ▲▼ to
highlight [NIGHT MODE], then press
OK
ON
Select this to level out the volume. This
feature is only available for movies with
Dolby Digital mode.
OFF
Select this when you want to enjoy the
full dynamic range of surround sound.
2 Press ▲▼ to select a setting, then press
ENTER/OK to confirm your selection.
26