Connecting By Manual Setting - Canon WU10 User Manual

Connecting by Manual Setting

To connect this device to a computer via an access point that does not support WPS, change the network mode of the device to AP mode, and
configure the device's network settings to suit the network environment.
CAUTION
• If the access point is using security settings (such as MAC address filtering), change the settings to allow connection to this device.
• To ensure good Wi-Fi communications, perform this procedure with the scanner initially located close to the access point.
1
Check the SSID of this device.
The SSID is printed on the device's bottom label.
SSID: WU10-XXXXXXX
18
2
Slide the mode switch to the "AP" side, press the
power button to turn the device on.
Power button