One Place Monitor Panel; Lp Gas Level; Water Pump Switch - Winnebago 2003 adventurer Owner's Manual

Table of Contents

Advertisement

SECTION 8
APPLIANCES & INTERIOR FEATURES
GENERATOR START/STOP SWITCH
See Section 6, Electrical Systems for genera-
tor start-up and shut-down instructions.
GENERATOR HOURMETER
See Section 6, Electrical Systems for genera-
tor hourmeter information.

ONE PLACE MONITOR PANEL

The OnePlace Monitor Panel provides a con-
venient central location for checking the condi-
tion of all utility systems in your coach. With a
touch of a button this panel can display the fresh
water and holding tank levels, LP gas tank level,
plus the engine battery and coach battery condi-
tion. You can start the auxiliary generator or turn
on the water pump and water heater. Indicator
lights tell you if the water pump and water heater
are on or if the water heater pilot light is out. It
also includes the climate control thermostat and
the PowerLine Energy Management System sta-
tus panel.
One Place Monitor Panel
8-8
Water and Holding Tank Levels
Press and hold the switch to show approxi-
mate level on the monitor lights.
Approximate levels of the fresh water and
holding tanks are measured by sets of electronic
probes in the sides of the tanks. The liquid must
be at or above a probe to illuminate the indicator
lights to a given level.
For example, a water level of 1-2" above the
1/3 probe would register as only 1/3 full. Conse-
quently, a level of merely 1" below the 1/3 probe
TM
would register empty. Generally speaking, there
is actually more liquid in a tank than indicated.
Tank Capacities
See back of "To The Owner" page inside
front cover of this manual.

LP Gas Level

Press and hold the switch to show approxi-
mate LP tank level.
The LP level is registered by a sending unit
on the tank. The gauge mounted on the side of
the tank will give a more accurate indication of
actual tank level if needed.

Water Pump Switch

When use of the self-contained water system
is desired, turn the "Water Pump" switch on. The
"Pump On" light will illuminate when the pump
switch is on and the system is operable. Water
will be available as soon as a faucet is opened.
Refer to "Fresh Water System" for additional
information on the water pump and initial start-
up.

Advertisement

Table of Contents
loading

Table of Contents