General Settings - Psm; Basic Procedure - JVC GET0253-003A Instructions Manual

General settings — PSM

Basic procedure

You can change PSM (Preferred Setting Mode)
items listed on the table that follows.
1
2
Select a PSM item.
Ex.: When you select "AMP GAIN"
Indications
DEMO
Display demonstration
CLOCK H
Hour adjustment
CLOCK M
Minute adjustment
AMP GAIN
Amplifier gain control
14
Selectable settings, [reference page]
DEMO ON: [Initial]; Display demonstration will be activated
automatically if no operation is done for about
20 seconds, [7].
DEMO OFF: Cancels.
0 – 23, [7]
[Initial: 0 (0:00)]
00 – 59, [7]
[Initial: 00 (0:00)]
You can change the maximum volume level of this receiver.
LOW PWR: VOL 00 – VOL 30 (Select this if the maximum power
of the speaker is less than 45 W to prevent them from
damaging the speaker.)
HIGH PWR: [Initial]; VOL 00 – VOL 50
3
Adjust the PSM item selected.
4
2
Repeat steps and
other PSM items if necessary.
5
Finish the procedure.
3
to adjust the