Table of Contents
Advertisement
DCS-VIP Internet Keyphone
1. Connect an Ethernet crossover cable (not included) to any of the Ethernet ports on the rear
panel of the DCS-VIP.
2. Connect the other end of the cable to an available port on your Ethernet hub, switch or
router.
¹
Connecting Digital or Analogue Telephones
You can connect a digital telephone to a DLI port on the rear panel of your DCS-VIP, and you
can connect an analogue telephone to an SLI port.
1. Connect the telephone cable to the port labelled DLI or SLI on the rear panel of your DCS-
VIP.
2. Connect the other end of the telephone cable to an RJ-11 port on your digital or analogue
telephone.
Note
1.
Cables with RJ-11 connectors at each end for use with DCS keyphones are available from your dealer.
2.
If a category 5 patch panel is to be used, a suitable RJ-11 to RJ-45 converter cable is required.
3.
A single line telephone may require a connector with a ringing capacitor fitted. These are available from
your dealer.
º
Connecting the Power Cord
When all of the cable connections to the DCS-VIP system are done, connect the provided power
cord as follows.
1. Connect the power cord to the power input connector on the rear panel of the DCS-VIP.
2. Connect the other end of the power cord to the electrical outlet.
Analogue phone
Digital phone
DCS-VIP router
DCS-VIP router
— 6 —
Quick Guide
Advertisement
Table of Contents
