Advertisement
• Trouble codes from zero (no LED's lit)
through 15 (all LED's lit) are used.
• When more than one code is stored:
–Each trouble code is presented
once.
–There is a 2 second pause between
codes.
5) Write down all displayed Trouble
Codes.
6) To view codes a second time, turn
the ignition key OFF and then back
to the ON position.
7) This completes trouble code
retrieval on these vehicles. Turn the
ignition key
OFF. (The
engine
computer is
back to
normal
operation.)
Look up the code definitions listed in
Section 9, "Honda Code Meanings."
At this point you can either:
• Have your vehicle professionally
serviced. Trouble codes indicate
problems found by the computer.
or,
• Repair the vehicle yourself using
trouble codes to help pinpoint the
problem. Refer to Section 3, "Using
Codes." Be sure to erase any trouble
codes from the computer's memory
after repairs are completed, as
follows.
• Verify that the
ignition key is in
the OFF position.
• Remove the
negative (-) battery
cable and wait 15
seconds.
• All the trouble
codes are now
erased from
computer memory!
• Reconnect battery
cable. You may
have to reset the vehicle clock, radio
stations, and so on.
Important: The computer has a
"learning" ability to take care of minor
variations in engine control operation.
Whenever you erase the computer
memory, the computer has to "relearn"
various things. Vehicle performance may
be noticeably different until it "relearns".
This temporary situation is normal. The
"learning" process takes place during
warm engine driving.
15
SECONDS
33
Advertisement
