Device Driver Installation - BT Speedway ISDN PCI card Installation Manual

Insert the other end of the ISDN cable into your ISDN or BT Highway
2.
socket.
Switch PC on.
3.
The physical installation of your Speedway ISDN PCI Card is now
complete.

3.3 Device Driver Installation

Depending on which version of Windows you determined earlier:
If you have:
Windows 95 version A:
Windows 95 version B:
Windows 98:
Windows NT:
A For Windows 95 Version 4.00.950 or 4.00.950a
Switch on your PC, if you have not already done so, and Windows will
1.
automatically detect the card you have just installed.
The 'New Hardware Found' screen will be displayed, announcing that it has
2.
recognised the BT Speedway PCI card as a 'PCI Network Controller'. If this
screen is not displayed, close down Windows, switch off your PC and check
that the card is physically installed correctly.
Select '
3. Driver from the disk provided by hardware manufacturer
Your PC will display a prompt asking you to insert the manufacturer's
4.
installation disk. Place the BT Speedway PCI Card CD in your PC's CD
drive.
Click , in the 'Drives' section and select your CD ROM drive letter.
5. Browse
Double-click on
double-click on
screen.
After the files are copied to your PC, the 'BT Speedway ISDN PCI Card'
6.
screen will be shown (Figure 2).
Complete Section 3.3,
Complete Section 3.3,
Complete Section 3.3,
Complete Section 3.3,
which will be shown in the 'Folders' section and
Cardware
. Click
Windows.95
Part A
Part B
Part C
Part D
and click again on the following
OK OK
& Part E.
& Part E.
& Part E.
& Part E.
', click .
OK
7