3.2 Installing the Speedway ISDN PCI Card
Switch off your PC and unplug the power connector cable.
1.
Remove the cover from your PC.
2.
Select an appropriate slot (Figure 1) and with a suitable screwdriver,
3.
carefully remove the screw from the adjacent protective plate from the rear
of the PC. Do not allow this screw to drop into the computer.
Figure 1 indicates a typical PC board showing how your card connectors
may be arranged. Note that the PCI card should be installed in one of the
smaller sockets.
Gently insert the card into the slot with the back plate facing the rear of the
4.
PC. Press down until the card is fully located into the slot. Do not disturb
the PC's internal wiring during installation.
Replace the retaining screw in order to secure the card back-plate to the
5.
rear of the PC.
Replace the cover of your PC, tighten any retaining screws and reconnect
6.
the power connector cable.
If you are in any doubt about how to access the inside of your PC, you should
contact your PC supplier for advice.
ISDN Connection
Take the ISDN cable supplied and insert the plug on one end of the ISDN
1.
cable into the socket on the rear plate of the Speedway ISDN PCI Card.
6
Figure 1
Warning