Benassi MC 2300 REVERSO Instruction And Maintenance Manual page 10

SpA
Never force the engine; when smoke comes out from the exhausting pipe, it means that the engine is under stress.
Do not work for long periods of time at full speed, in particular during warm periods.
Periodically control the tyre pressure ( Atm. 1,3)
During the mounting of the different tools do not damage the dowels (Ref. "D" Picture 8) and the splines, control that screws and the
fastening spine of the tools are well locked, especially screws of the mill hoes and the fastening screws of the cutterbar.
Do not leave the machine under the rain.
ATTENTION, IT IS DANGEROUS:
To touch the just switched off engine (some parts may burn).
To move with the cutterbar without protection.
To execute the operations of transport, maintenance, repair and lubrication with the engine not switched off and without all the
protections mounted.
On means of transport the machine must be well fastened with proper locking.
The cutter protections must be adjusted according to the depth of the work , so that the part of the tool which cuts the ground remains
uncovered; never make hoeing operations without the back hood panel on the machine.
Keep always efficient the safety disposals ( above all the automatic engine stop ) and the protections of the rotating elements.
Before starting to work make sure there are not persons or obstacles in the machine range of action inferior to 5 meters.
Wear proper shoes and clothes, do not wear large or fluttering clothes (scarf or foulard).
Never work in sloping grounds without having assured the machine stability. Attention! Do not work in grounds with a more than 50 %
slope.
Keep the fuel in proper tanks.
The refuelling must be done in airy places, with the engine switched off and cold. During this operation do not smoke, if the fuel comes
out (especially petrol) dry the wet parts and if possible blow away with compressed air, move the machine in a dry place before starting
it.
To move the machine from a work ground to an another one or during the reverse manoeuvres, before starting the work again always
disengage the power take-off to stop the moving organs.
The waste disposal of lubricators and batteries must be done in conformity with the rules in force in the country where the machine is
used.
Before leaving the machine, disengage the power take-off, stop the engine and take away the plug spark cap.
Read carefully the Use and Maintenance booklet provided with the machine.
The use of the machine is forbidden to persons under 16 .
The operator is responsible for the damages, since he is the driver of the machine.
Dry the petrol leakage.
Refill the tank with the engine switched off. The refuelling and/or the fuel pouring off must always be done outside, far from fire or heat
sources. Do not smoke during this operation.
Before starting to use the engine driven cultivator, it is necessary to learn how to rapidly switch the engine off, to familiarise with the
drives and to learn how to properly use the machine. Do not make the engine run where outlets with carbonic oxide could accumulate.
We disclaim all responsibility for incidents caused by non-observance of these rules.
ATTENTION: during the continuative use of the machine the
use of hearing protection devices is recommended.
10
20 – ACCIDENT‐PREVENTION RULES
To leave the engine running in closed rooms; exhaust gases are highly toxic.
To refuel with the engine running or overheated.
To accelerate going to reverse; the engine must be at minimum speed.
To make tests, to clean and to repair tools (milling cutter, cutterbar, lawn mower etc.) with the engine
running.
MC 2300