Special SettingS
power saving function
The TAD-D600 is factory set to the ECO ON mode (power-saving mode), so that it automatically enters the standby mode
when unused for 30 minutes.
The power-saving mode can be changed as follows:
11
Press the main unit's front panel
the standby mode1
The power unit's front panel power indicator will light red.
21
While holding the main unit's front panel
Press the main unit's front panel button to set ECO OFF (disable power-saving mode), and press the main unit's
front panel button to set ECO ON (power-saving mode).
Suppress SacD output level for listening
When playing SACD, if the output is too high and produces distorted sound, this setting will lower the output level to make
for easier listening. At the time of purchase, the factory default setting is DSD modulation 50 % (high output level).
•
While holding the main unit's front panel
Each time the button is depressed the output level alternates between 50 % (high output) and 100 % (low output).
High Sampling Mode Output
Allows conversion of digital music sampling rate to 44.1 kHz for digital output. At time of purchase, the factory default
sampling rate is set by the upsampling converter to 8812 kHz.
•
While holding the
Each time the button is pressed, the sampling rate alternates between 4411 kHz and 8812 kHz. Note that in the case of
SACD, the sampling rate is fixed at 4411 kHz.
Using the taD-D600 as a D/a converter
•
With the play mode set to stop, press the main unit's front panel DAC button (or the remote control unit's DAC
MODE button)1
Each time the button is pressed, the mode alternates between "D1 input (XLR)", "D2 input (coaxial)", and "Disc play
mode".
When an input signal is received, "In" is displayed; when no signal is being received, "−−" is displayed.
18
button (or the remote control unit's DISC PLAYER button) to set the TAD-D600 to
h button depressed, press the main unit's front panel button1
button depressed, press the main unit's front panel button1
button depressed, press the button1