Power Unit Rear Panel / Main Unit Rear Panel - TAD D600 Owner's Manual

Power unit rear panel / Main unit rear panel

Power Unit
DC2
DC OUTPUT DC1
AC IN
ON
POWER
OFF
1 2
1 Main power switch (POWER ON/OFF)
Use to switch main power ON/OFF. Press upper side to turn power ON, then press the  button on the remote control or
main unit to set the unit to standby/ON mode. Press the lower side of this switch to turn the main power OFF.
2 AC IN connector
Connect the supplied power cord here.
3 DC OUTPUT connectors (DC1/DC2)
Connect one end of the accessory DC cord here, and the other end of the cord to the main unit's DC 1/DC 2 INPUT
connectors.
4 DIGITAL INPUT connectors
Connect to a component equipped with a digital output connector.
• XLR (balanced) type (D1)
• COAXIAL type (D2)
5 DIGITAL OUTPUT connector
Connect to a component equipped with a digital input connector.
• XLR (balanced) type
6 DC INPUT connectors (DC1/DC2)
Connect one end of the accessory DC cord here, and the other end of the cord to the power unit's DC 1/DC 2 OUTPUT
connectors.
7 ANALOG OUTPUT connectors
Connect to Pre-Amplifier
• UNBALANCED RCA type
• BALANCED XLR type
Main Unit
DIGITAL INPUT
COAXIAL XLR
D2 D1
2
3
XLR
DIGITAL OUTPUT
3 4
1
DC2 DC1
DC INPUT
5
ANALOG OUTPUT
R L
UNBALANCED
BALANCED
1. GROUND
2. HOT (+)
3. COLD (-)
R L
BALANCED
6 7
13