Remote Control Unit - TAD D600 Owner's Manual

remote control unit

DISC PLAYER OPEN/CLOSE
1
TIME DISPLAY OFF
2
SACD/CD DAC MODE
3
1 2
4 5
4
7 8
0
CLEAR ENTER
5
6
REPEAT
7
AMP
VOLUME
MUTE
DISC PLAYER
CXE3196
1 DISC PLAYER  button
Use to set power to ON/standby
mode.
remote control operating range
When using the remote control unit to operate the TAD-D600, point the remote control at
the main unit's remote sensor within the ranges shown in the accompanying illustration.
The remote control may not operate properly if obstructions exist between the
'
remote control unit and the remote sensor, or if the angle between the remote
control and the remote sensor is poor.
Malfunctions may occur if the TAD-D600 is used nearby other appliances that emit
'
infrared light, or if remote control units for other devices utilizing infrared light are
used nearby. Alternately, using this remote control unit near other appliances that also utilize infrared light may cause
those appliances to malfunction.
Replace the batteries when you notice a reduction in the operating range of the remote control unit.
'
The remote control may not operate correctly if strong sunlight or light from fluorescent lamps is allowed to strike the
'
remote sensor directly. In such cases, change the installation location, or remove the fluorescent lamps to a more
distant location.
14
2 tImE button
Press to display the disc's elapsed
and remaining playing time. Each
8 time the button is pressed, the
display alternates as follows: "track
9
remaining time" / "disc remaining
10
time" / "elapsed time".
3 SACD/CD button
3
Press to switch between play areas
of hybrid discs. Each time the
6
button is pressed, the playing area
9
alternates between "CD area" and
"SACD area".
11
4 Number buttons
Use to designate specific tracks
for playback. Press the desired
number button to select, followed
by the ENtER button to confirm the
selection.
5 CLEAR button
Press to cancel a currently input
12
item. For example, this is useful
when an improper track number
has been input.
6 Play operation buttons
 – Play disc.
g – Stop disc play.
e – When pressed during playback,
pauses the disc play at its current
position. Press the button again to
resume playback.
m – Press during playback to
perform quick reverse.
 – Press during playback to
return to the beginning of the
currently playing track.
n – Press during playback to
perform fast forward.
 – Press to advance to
beginning of next track.
7 REPEAt button
Each time the button is pressed the
repeat play mode alternates in the
following order:
All track repeat
1 track repeat
Repeat OFF
8 OPEN/CLOSE button
h
Press to open and close the disc
tray.
9 DISPLAY OFF button
Press to turn off display.
10 DAC mODE button
Press to switch DAC mode. Each
time the button is pressed the mode
alternates as follows:
"D1 input (XLR)" / "D2 input
(coaxial)" / "Disc play mode"
11 ENtER button
Press to confirm settings and
selections
12 Amplifier operation buttons
These buttons can be used to
operate a Pioneer TAD amplifier.
AmP  – Amplifier power ON/
standby
VOLumE – Use to adjust sound
volume.
mutE – Press to temporarily mute
the sound.
Remote sensor
Remote 30°
control unit
30°
7 m (23 ft.)