Renault FLUENCE Technical Training Manual page 36

Technical Specifications
Airbag Systems
Front impact sensors
Connect the front impact sensor connector
Refit: the front side door run channel mounting
- Refit the door sealing films - the front side door trim.
Final operation for the two side impact sensors; Connect the battery
- carry out the operations described in the « After repair Procedure » section.
Front seat lap belt pretensioner
Removal
Disconnect the battery - remove the front seat, remove the front seat base outer cover, remove
the front seat lower casing, Mark the wiring routing on the seat frame. Disconnect the
connector (2) of the front seat lap belt pretensioner.
Remove: the bolt (3) of the front seat lap belt pretensioner,
- remove the front seat lap belt pretensioner.
After a seat belt pyrotechnic component is triggered, it is essential to replace certain parts, do
not reuse pyrotechnic components. Always replace the bolt of the front seat lap belt
pretensioner. Refit the front seat lap belt pretensioner by positioning the anchor point (4) in the
seat base frame. Torque tighten the bolt of the front seat lap belt pretensioner (25 N.m). Refit
the wiring in the position marked during the removal operation. Connect the connector of the
front seat lap belt pretensioner. Lock the connector of the front seat lap belt pretensioner.
Check that the seat belt is not twisted between the front side seat belt return mechanism and
the lap belt pretensioner. Clip the front side seat belt onto the lap belt pretensioner. Check that
the front side seat belt is correctly clipped in place, pull on the front side seat belt and check
that the front seat belt strap remains clipped onto the pretensioner. Connect the battery Switch
on the ignition. Check that there are no faults on the instrument panel.
Page 36
Technical Training Renault Fluence