Table 5 Battery Replacement Procedure - Honeywell OWA 100 User Manual

Step
ATTENTION
Use only the following 3.6V lithium thionyl chloride (Li-SOCl2) batteries (non-rechargeable),
size D. No other batteries are approved for use in OWA 100 Adapter.

Xeno Energy XL-205F

Eagle Picher PT-2300H

Tadiran TL-5930/s
Loosen (4) M4 screws and remove the cover.
1
Disconnect J2 connector
2
Remove the old battery from the battery holder. If needed, pry out the battery by using a
3
slotted screwdriver as a lever.
Reconnect J4 connector
4
Install battery as follows to avoid snagging the battery terminal on the clip and damaging the
5
battery.
Align the new battery with the clips and angle the positive (+) end of the batteryinto the positive
(+) battery terminal clip. Using a thumb and forefinger pull the negative terminal clip outward
and push down on the battery until fully seated in both clips. Do not apply excessive force
when pushing the battery down.
Replace the cover and tighten the (4) M4 screws with a torque of 1.0 N.m / 9.0 lbf-inch.
6
Dispose the used battery promptly per local regulations or the battery manufacturer's
7
recommendations. Keep away from children. Do not disassemble and do not dispose of in
fire.
30

Table 5 Battery replacement procedure

Action
OWA 100 Adapter User Manual Rev. 2
July 2011