Step 10: Set Scsi Ids On Drives; Step 11: Install New Mounting Brackets - Digital Equipment 900 AXP Information

Upgrade Procedure
If your DEC 3000 system has a factory-installed disk drive, it is
Step 10: Set
SCSI IDs on set to SCSI ID 3.
Drives
Check the SCSI ID settings you noted earlier. If one of the drives
you are upgrading is set to SCSI ID 3, then change that setting.
See Appendix A for the SCSI ID drive settings.
Step 11: Install To attach the new mounting bracket and rubber grommets to a
fixed disk drive, follow these steps:
New Mounting
Brackets
1. Place the metal support plate on the disk drive as shown in
2. Screw the four rubber grommets (from your accessory kit)
Metal Support
Plate
2–10 Upgrading a VAXstation 4000 Model 90/90A
the following figure.
onto the plate and the drive until the plate is secure.
Rubber
Grommets
MLO-010588