Table of Contents
Advertisement
6 Mini-MT Configuration
The Mini-MT must be configured before use. Configuration is performed through AT
commands from a PC computer. A terminal program is required to interface to the Mini-
MT through the USB cable. HyperTerminal is a terminal program that may be supplied
with your computer operating system and is used in this document for examples.
The Mini-MT drivers must be installed on your computer before proceeding. Refer to
Section 7: Software Installation of this document for driver installation.
6.1 Dispatch Number
The "Dispatch Number" is the phone number the Mini-MT will call when the Push-To-
Call (PTC) button is pressed.
To configure the Mini-MT to call phone number "1-214-555-1212" enter the following
command:
AT$DSPATCH="12145551212" <Enter>
After entering the dispatch number enter: AT&W <Enter> to save. This will ensure that
if the battery is removed the number will not need to be re-entered.
6.2 SMS Destination
The SMS Destination Address is where the Mini-MT would send an SMS text message.
The Mini-MT can store up to five (5) SMS Destination Addresses. The following
example shows how to set an SMS Destination Address:
AT$SMSDA=1, "19875551212"<Enter>
GSM2228AN001
Page 10
Advertisement
Table of Contents
