Sim Card Insertion / Removal - Enfora Mini-MT GSM2228 Quick Start Manual

NOTE: The PC must be turned on or powered up while charging the Mini-MT.
For charging the Mini-MT battery in a vehicle an optional USB to vehicle accessory
power adapter is available (PSA-9000-0002).
NOTE: Many vehicles do not provide power to the accessory jack when the
vehicle ignition is off.
An alternate method for charging using AC power may be performed with the AC power
to USB power adapter (PSA-9000- 0101).
Connect one end of the USB cable to the Mini-MT and the other end to your power
source. The Mini-MT ON LED will be illuminated solid and the BAT LED will flash
while charging.
When the Mini-MT is fully charged the BAT LED will be extinguished and the CALL
LED will be illuminated solidly while connected to a USB power source.

5 SIM Card Insertion / Removal

The Mini-MT requires an activated SIM card to operate on the GSM network. The SIM
card is located under the battery. Remove the battery door and the battery when
accessing the SIM cardholder. (See battery Insertion / Removal section of this document)
Note:
!
The tray has a sliding latch for retention of the SIM card. The tray must be opened
before a SIM card can be inserted or removed.
Slide the tray to the "unlatched" position and pivot the tray outward.
Insert (or remove) the SIM card, pivot the tray back into the holder and slide the tray to
the "latched" position. Care should be taken to ensure proper orientation of the SIM card
in the tray before closing.
GSM2228AN001
The SIM card is not provided with the Mini-MT device. The SIM
must be obtained from the GSM/GPRS service provider and
must be provisioned by the operator for data and/or voice.
Always take care to protect the SIM. Without the SIM installed,
the Mini-MT is limited to emergency voice communication only.
Ensure the power to the Mini-MT is disconnected including
disconnecting from USB cable before inserting the SIM card.
Failure to do so might result in an unusable Mini-MT or a
damaged SIM card.
Page 9