Fcc Regulations - NEC Medias NE-103T User Manual

Hide thumbs Also See for Medias NE-103T:
Table of Contents

Advertisement

and can be found under the Display Grant section at
http://www.fcc.gov/oet/ea/fccid after search on FCC ID
A98-JDM2910.
For body worn operation, this phone has been tested and
meets the FCC RF exposure guidelines when used with
an accessory designated for this product, or when used
with an accessory that contains no metal and that
positions the handset a minimum of 1.0 cm from the
body.
Non-compliance with the above restrictions may result in
violation of FCC RF Exposure guidelines.
---------------------------------------------------------------------------
* In the United States, the SAR limit for wireless mobile
phones used by the public is 1.6 watts/kilogram (W/kg)
averaged over one gram of tissue.
SAR values may vary depending upon national reporting
requirements and the network band.

FCC Regulations

This mobile phone complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This product may not cause harmful
interference, and (2) this product must accept any
interference received, including interference that may
cause undesired operation.
This mobile phone has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation.
This product generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation; if this product does cause harmful
interference to radio or television reception, which can be
determined by turning the product off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the product and
receiver.
• Connect the product into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio / TV
technician for help.
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
60
Appendix

Advertisement

Table of Contents
loading

Table of Contents