Installation - King-Dome 9702 Installation And Operating Instructions Manual

IMPORTANT! The tie strap and spacer, and the bolts and washers must be removed
from the bottom of the dome unit prior to installation. DO NOT REMOVE
THE DOME COVER TO REMOVE THESE SHIPPING RESTRAINTS.
YOU MUST PLUG THE SHIPPING BOLT HOLES WITH THE SUPPLIED
PLUGS (ATTACHED TO TIE STRAP SHIPPING RESTRAINT).
2. Remove and discard the tie strap and spacer (KEEP RUBBER PLUGS), and the (2) bolts
and (2) washers that pass through the bottom of the base (Fig. 5).
3. Insert provided plugs into holes that were occupied by the shipping bolts. Inserted plugs
should be flush with base (Fig. 5).
Fig. 5
After removing shipping bolts, firmly
insert plugs into holes. Plugs should
IMPORTANT!
Remove and discard
Tie Strap and Plastic
Spacer prior to

installation.

KEEP RUBBER
PLUGS.
IMPORTANT!
Remove and discard
Bolts and Washers
prior to installation.
IMPORTANT!
be flush with base.
Page 5