Installation - King-Dome 9702 Installation And Operating Instructions Manual

Automatic satellite system
Hide thumbs Also See for 9702:
Table of Contents

Advertisement

TOOLS AND MATERIALS REQUIRED:
- drill and drill bit set
- tape measure
- 7/16" open end wrench (coax connections)
- adhesive sealant (compatible with roof material)
- appropriate fasteners to install all components and wiring
- 5/32" allen wrench, channel lock or pliers (to remove shipping bolts)
- wire cutter (to remove shipping tie strap)
KIT CONTENTS:
1. Unpack and identify all components (Fig. 4).
Fig. 4
Page 4

INSTALLATION

SECTION 3
KIT CONTENTS
King Dome Operating Instructions
1. Turn tv and satellite receiver ON.
The tv screen should display "Searching for Satellite"
or "Acquiring Satellite Signal."
IMPORTANT DO NOT USE THE TV OR RECEIVER
CONTROLS UNTIL YOU HAVE FOUND A
SATELLITE.
2. On King-Dome controller, press and hold ON/SEARCH
for 3 FULL SECONDS.
3. Wait for status light to turn steady green.
4. Turn to a satellite channel that you normally watch.
Is there a picture?
YES
Press OFF and enjoy your programming.
NO
Press ON/SEARCH until the Status Light begins
flashing and go back to step 3.
DO NOT turn the system OFF until you lock onto the
satellite with your programming.
5. Questions? Refer to owner's manual
King-Dome

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

9702-lp

Table of Contents