King-Dome 9702 Installation And Operating Instructions Manual page 12

INTERNAL WIRING
14. Inside the vehicle, make the connections as shown in Fig. 11, keeping in mind the
following important points:
a) The connection between the dome unit and the receiver must be a direct
connection with no devices in between. Any other devices should be downstream
from the receiver. Do not go through an "A-B" or any other switch, box, or booster.
b) Power connection must be a non-shared circuit. Excessive current draw on the
circuit will cause the unit to operate improperly. Power and ground connections must
be made after the wires are connected to the dome unit.
Fig. 11
Page 10
POWER STATUS
ON / SEARCH OFF
CHANGE SATELLITE
92° 101° 110° 119°
ON/SEARCH
STATUS
119
110
101
OFF SWITCH
SATELLITE