Security - Leviton VRCPG User Manual

ASSOCIATION screen. A list of
controllers included in Step 2
that support association will be
displayed.
Scroll to and press the center
button to select the controller
you wish to associate an area or
areas to.
The CONTROLLER ASSOC
screen will display with the
selection box around 1. Button
prompting you to select the
button on your controller that
you wish to associate an area to.
Use side arrow buttons
toggle if applicable.
Scroll to 2 Area and choose an area you wish to
associate to the button you've selected. This will
allow the button on the chosen controller to control
the desired area.
Selecting 3. Area ON/Off allows you to set an
AREA ON/Off or SCENE command to that button
on your controller (for SCENE commands refer to
Advanced Settings).
Once you are done press the right soft key
(Save) to complete. You will be prompted to
continue setting associations or to proceed to the
NEXT STEP by pressing the right soft key
STEP 6
NOTE: The INSTALL
CHECKLIST screen will appear
with the selection box around
STEP 6 - Security when NEXT
STEP is chosen from STEP 5.
Press the center button
bring up the SECURITY screen.
Press the center button
select 1. Setup Password.
Enter password using four of the
eight buttons on the VRCPG
(1 ON, 1 Off, 2 ON, 2 Off etc.)
NOTE: The password you
choose MUST be 4 characters
long.

Security

8:35A
ASSOCIATION
Room Controller
Hall Controller
Den Controller
Back
8:35A
CONTROLLER ASSOC
Dev: Room Controller
1. < Button 1 >
2. Area #1
3. Area ON/OFF
Cancel
to
8:35A
INSTALL CHECKLIST
2. Include Controller
3. Update Controller
4. Create Areas
5. Set Associations
6. Security
to
Back
to 8:35A
SECURITY
1. Setup Password
2. < OPEN >
Cancel
x1
Next Step
x1
Save
.
x1
Next Step
x1
Save
11