Create Areas - Leviton VRCPG User Manual

Press the center button
bring up the UPDATE CNTRLS
screen where a list of all the
controllers in the network will be
displayed. With the selection box
around the first controller listed
press the center button
VRCPG will prompt you to stand
within 3 feet of that controller.
Press the right soft key
to update your controller. NOTE:
It is important that you remain
within 3 ft. of the controller
you've selected from the list.
If you are unsure about which
controller you are updating you
can use the "who Is" command
(see pg. 13). Leviton controllers
will blink during the update
process, confirming you are
updating the correct controller.
Once the VRCPG confirms
UPDATE it will display the updated node information.
Press the center button
Continue this process until all of your controllers
have been updated. Each time you successfully
update your controller it will be removed from the
list. Once all of your controllers have been updated,
press the right soft key
STEP.
STEP 4
NOTE: The INSTALL
CHECKLIST screen will appear
with the selection box around
STEP 4 - Create Areas when
NEXT STEP is chosen from
STEP 3. NOTE: Areas are a set
of devices that will be controlled
as one.
Press the center button
bring up the AREA screen. With
<< NEw >> selected press the
center button
CREATE AREA screen.

Create Areas

to bring up the
to
8:35A
UPDATE CNTRLS
Back
. The
8:35A
(YES)
Please stand within
3 ft from controller
and press YES
to continue
NO
8:35A
Node ID #4
Room controller
to finalize.
to continue to the NEXT
8:35A
INSTALL CHECKLIST
1. Include Dim/Swch
2. Include Controller
3. Update Controller
4. Create Areas
5. Set Associations
Back
8:35A
to
Back
x1
Room Controller
Hall Controller
2/2 Who Is
x1
UPDATE
YES
x1
UPDATE
Node Updated!
Finalize? Press
x1
Next Step
x1
AREA
<< NEW >>
Select? Press
Next Step
9