Pride Mobility Jazzy Select 14 Series Owner's Manual page 24

V . C O M F O R T
Manual Recline Seatback Adjustment
If your power chair is equipped with a reclining seat, you can
adjust the seatback angle with the seatback release lever. The
lever is located on the right side of the seat base.
To adjust the recline angle:
1. Pull up on the seatback release lever.
2. Lean forward or backwards to the desired position.
3. Release the lever.
Seatback Angle Adjustment
If your power chair is equipped with an adjustable seatback, you
can adjust it to four (4) different angles: 90°, 102°, 105°, or 107°.
To adjust the seatback angle:
1. Remove the adjusting screws from each seat hinge. See fig-
ure 13.
2. Set the seatback at the desired angle.
3. Reinstall the adjusting screws to each seat hinge and tighten.
Armrest Width Adjustment
You can change each armrest's width independently of the other.
NOTE: Changing the armrest width may increase the over-
all width of your power chair.
To change the armrest width:
1. Locate the two armrest knobs on each side of the armrest
receiver bracket. See figure 13.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Tighten the knobs.
Armrest Height Adjustment
To change the armrest height:
1. Loosen the setscrews located on the on the armrest re-
ceiver. See figure 13.
2. Raise or lower the armrest to the desired height.
3. Tighten the setscrews to secure the armrest.
Armrest Angle Adjustment
To change the armrest angle:
Lift the armrest straight up so that it is perpendicular to the
1.
floor. See figure 13.
2. Loosen the jam nut.
3. Turn the adjusting screw to raise the front of the armrest or to
lower the front of the armrest.
4. Tighten the jam nut to secure the adjusting screw into place.
24
A D J U S T M E N T S
JAM NUT
ARMREST ANGLE
ADJUSTING
SCREW
ARMREST
HEIGHT
ADJUSTING
SETSCREWS
SEATBACK ANGLE
ADJUSTING
SCREW
ARMREST KNOB
Figure 13. Seatback and Armrest Adjustments
www.pridemobility.com Jazzy Select 14 Series