HOW TO USE
The air quality sensor is set at the standard sensitivity. You may need to adjust the
sensitivity of the sensor if the particle sensor indicates 'not clean' even after 2 hours
of operation or 'very clean' even though the air does not seem good.
Particle sensor
�
Press both the speed and mode buttons
for more than 2 seconds.
�
The icon of 'Speed Lamp' blinks to
indicate the adjustment of sensitivity of
pollution level.
�
Press the speed button to choose the
sensitivity. The chosen sensitivity is
displayed on the dust
pollution STEP.
�STEP 1 : Sensitive
�STEP 2, 3 : Normal
�STEP 4 : Insensitive
�
Press both the speed and mode buttons
for more than 2 seconds to save the
sensitivity.
�If no button is pressed
for 10 seconds, the
sensitivity is automatically
saved.
19
�
�
CLEANING METHOD
Always unplug the unit before cleaning.
Cleaning the particle sensor
●
Open the particle sensor cover of the unit. Use a wet cotton
swab to clean the lens and wipe up any remaining moisture.
Cleaning the unit
●
Use a dry and soft cloth to clean the unit.
Use a wet cloth if necessary but do not use
a polisher.
Cleaning the pre-electrostatic filter
●
Use a vacuum or water to dust off the filter,
and use after the filter is completely dried.
(Every 2 Months)
�
(Every 2~4 Weeks)
20