Related Manuals for Hoover Mode
Summary of Contents for Hoover Mode
- Page 1 MODE Bagged Vacuum Cleaner with Powerhead Compact Powerhead for a Powerful Clean Washable HEPA Filtration High Efficiency Soft Start Motor Mode High Efficiency Motor...
- Page 2 10 11...
-
Page 3: Specifications
Mode Congratulations on the purchase of your new HOOVER vacuum cleaner. There are many useful features built into your vacuum and we recommend that you carefully read this instruction manual so that you may take best advantage of them. Features: 1. -
Page 4: Before You Begin
Before you Begin The cleaner must be operated in accordance with these instructions and used only for domestic household cleaning to remove DRY dirt and dust from household carpets, flooring and fabrics. This cleaner is not fit to be used as an industrial cleaner, and is not designed for the collection of vitreous building material including particle board, construction products and similar products such as wood/fibres, cement, fillers, fibre glass etc or excessive or frequent sand. - Page 5 Before you Begin Precautionary measures: If the opening that sucks in the air, the suction pipe or the telescopic wand are blocked, you should switch off the vacuum cleaner at once. First clear the blocked substance before you attempt to start the vacuum cleaner again. Do not operate the vacuum cleaner too close to heaters and like radiators, cigarette butts etc.
-
Page 6: Safety Precautions And Warnings
Safety Precautions and Warnings IMPORTANT! Always switch off the cleaner and remove the plug from the electricity power supply before cleaning your appliance, when not in use or attempting any maintenance task. The cleaner must only be connected to an AC power supply at the voltage shown on the rating label. - Page 7 17. Before vacuuming, remove any large or shaft Do not pickup water dry household use only objects from the floor or cleaning surface in 29. Damage caused by improper use or by order to prevent damage to the filter. observing the instructions in this manual will void warranty.
- Page 8 Assembly IMPORTANT! Always remove the plug from the power socket before fitting or removing accessories. 1. Fitting or removing the flexible hose Fitting: Insert flexible hose into the air intake duct on the top of appliance. Press until it clicks into position. Removing: Remove the plug from the power socket and then release the flexible hose from the air intake duct by depressing the two buttons.
-
Page 9: Crevice Tool
Ideal for daily cleaning on carpets and hard floors*. * Powerhead is NOT ideal for hard floors Carpet Hard Floors Accessories Crevice tool For radiators, crevices, corners, baseboards and between cushions. Upholstery tool For vacuuming furniture and upholstery. Dusting brush For furniture, blinds, bookshelves and lamp shades. -
Page 10: Instructions For Use
Instructions for Use IMPORTANT! Before using the appliance, unwind a sufficient length of cable and insert the plug into the power socket. A yellow mark on the power cable shows the ideal cable length. Don’t expend the cable beyond the red mark. 1. -
Page 11: Maintenance
Maintenance IMPORTANT! Ensure the vacuum cleaner is not connected to the power supply when performing any maintenance procedures. Use a damp cloth and mild detergent when cleaning the appliance. Vacuum Cleaner Storage When not in use, ensure the cleaner is not connected to the power supply, and pull the power cable gently out of the power socket. - Page 12 Maintenance (continued) Changing the Dust Bag (continued) 4. Remove the dust bag when it is full and replace with a new one. 5. Replace the bracket and dust bag assembly. 6. Gently close the cover, you will hear it click closed. Motor Filter Replacement WARNING! Ensure the cleaner is not connected to the power supply when performing any maintenance procedure.
- Page 13 Exhaust Filter Cleaning or Replacement 1. Open the dust bag cover and remove the exhaust filter. 2. Clean the filter with lukewarm water (no soap) and allow 24 hours to air dry before reinstalling. 3. It is recommended to replace the exhausted filter every 6 months.
- Page 14 Maintenance (continued) Changing the Motorised Powerhead Drive Belt (continued) 2. Turn the powerhead upside down and squeezing the locking tabs, remove the bottom plate. 3. First lift up the end of the rotating brush with no belt and remove it. Then lift the end cap where the belt loops around.
-
Page 15: Troubleshooting
Check the appliance to ensure there are no blockages. Please clear any blockages that may be found. Please contact Hoover Customer Care: 1300 360 845, NZ: (09) 263 7573 to find your local spare parts provider. Part Dust Bag 4Pk Filter Kit –... -
Page 16: Conditions Of Warranty
Conditions of warranty Your Hoover cleaner, in the case of domestic use, has a two Hoover Floorcare is unable to accept responsibility year parts and labour warranty against product defects under this warranty for any repair work not carried out...