Charging The Battery Using The Hähnel Mcl103; C Harging The B Atteries - Leaf Aptus II Installation Manual

14
Charging the Batteries
You can charge the lithium ion battery used with the Leaf AptusII camera
back using the MCL103 battery charger provided. .
Charging the Battery Using the Hähnel MCL103
Attention: Before performing these procedures, refer to the Safety *XLGH
RQ WKH DFFRPSDQ\LQJ &'.
To charge the battery with the 12V DC Power Supply:
1. Connect one end of the 12V DC power supply cable to the Kähnel
2. Connect the 12V DC power supply to a wall outlet, using the cable
Note: The 12V DC power supply is designed for use with both 110V and
220V input voltages.
Attention: Do not use any power supply cables other than the cable
provided.
3. Insert the battery with contacts facing down and slide the battery fully
MCL103 battery charger.
provided.
Figure 11: Connecting the hähnel MCL103 battery charger
down into the contacts.
Once charging begins, an indicator light turns on.
The indicator light begins to flash when the battery is almost charged.
Charging is complete when the indicator light turns off.
 the Batteries