Other Convenient Tuner Functions; Scanning Broadcast Stations; Selecting Fm Reception Sound; Changing The Am/Fm Channel Intervals - JVC KD-SX838/S737 Instructions Manual

Other convenient tuner functions

SEL

Scanning broadcast stations

When you press SCAN/INT (Scan/Intro) while listening to the radio, station scanning starts.
Each time a broadcast is tuned in, scanning stops for about 5 seconds (tuned frequency
number flashes on the display), and you can check what program is now being broadcast.
If you want to listen to that program, press the same button again to stop scanning.

Selecting FM reception sound

When an FM stereo broadcast is hard to receive:
Press MO/RND (Mono/Random) while listening to an FM stereo broadcast. The sound you
hear becomes monaural but reception will be improved.
Lights up when receiving an FM broadcast in stereo.
To restore the stereo effect, press the same button again.

Changing the AM/FM channel intervals

When using this unit in an area other than North or South America:
When this unit is shipped from the factory, the channel intervals are set to 10 kHz for AM and
200 kHz for FM. You can change the channel intervals by following the procedure below.
1 Press SEL (select) for more than 2 seconds.
"CLOCK H," "CLOCK M," "BEEP" or "AREA" appears on the display.
2 If "AREA" does not appear, press SSM ¢
3 Rotate the control dial clockwise.
"AREA EU" appears and the channel intervals are set to 9 kHz for AM and 50 kHz (for
manual tuning) / 100 kHz (for searching) for FM.
To reset to the factory setting, follow the above step 1 and 2, then rotate the control dial
counterclockwise in step 3 ("AREA US" appears on the display.)
AREA EU: Select this when used in an area other than North and South America.
AREA US: Select this when used in North or South America.
SSM ¢
SSM 4
Control dial
MO
RND
SCAN
INT
or SSM 4
until it appears.
9