Other Convenient Tuner Functions; Scanning Broadcast Stations; Selecting Fm Reception Sound; Changing The Am/Fm Channel Intervals - JVC KS-FX250 Instructions Manual

Other convenient tuner functions

Control dial

Scanning broadcast stations

When you press SCAN while listening to the radio, station scanning starts. Each time a
broadcast is tuned in, scanning stops for about 5 seconds (tuned frequency number flashes
on the display), and you can check what program is now being broadcasted.
If you want to listen to that program, press the same button again to stop scanning.

Selecting FM reception sound

When an FM stereo broadcast is hard to receive:
Press MO/RND (mono/random) while listening to an FM stereo broadcast. The sound you
hear becomes monaural but reception will be improved.
Lights up when receiving an
FM broadcast in stereo.
To restore the stereo effect, press the same button again.

Changing the AM/FM channel intervals

When using this unit in an area other than North or South America:
When this unit is shipped from the factory, the channel intervals are set to 10 kHz for AM and
200 kHz for FM. You can change the channel intervals by following the procedure below.
1 Press SEL (select) for more than 2 seconds.
"CLOCK H", "CLOCK M", "SCM LINK", "LEVEL", "AREA", "B.SKIP" or "LINE IN " appears
on the display.
Displayed only when one of the following sources is selected — FM, AM and TAPE.
2 If "AREA" does not appears, press
3 Press +.
"AREA EU" appears and the channel intervals are set to 9 kHz for AM and 50 kHz (for
manual tuning) / 100 kHz (for searching) for FM.
To reset to the factory setting, follow the above step 1 and 2, then press – in step 3 ("AREA
US" appears on the display.)
AREA EU: Select this when used in an area other than North and South America.
AREA US: Select this when used in North or South America.
8
SCAN
SEL
¢ or
MO/RND
4 until it appears.
¢
4