External Component Operations; Playing External Components - JVC KD-SH55R Instructions Manual

EXTERNAL COMPONENT OPERATIONS

Playing external components

For KD-SH77R:
You can connect two external components to this
unit.
Connect one to the auxiliary input jack on the
control panel, and the other to the LINE IN plugs
on the rear.
If you connect a JVC's VCR or DVD player
to the LINE IN plugs
You can operate it through this receiver using
the number buttons on the control panel.
When you operate the VCR, you have to
change the operation mode of the number
buttons from the DVD operation mode to the
VCR operation mode. (See "To select the
target component to operate through this
receiver – KEY SELECT" on page 26.)
If the input level of the external
components is not high enough, increase
the input level properly.
Without adjusting the input level, you may be
surprised at a loud sound when you change
the source from the external components to
another. (See "To adjust the line input level –
LINE ADJ" and "To adjust the auxiliary input
level – AUX ADJ" on page 26.)
30
MD player, etc.
1
Select the external component (AUX
INPUT or LINE INPUT).
When you select a source,
the power automatically
comes on.
Each time you press the
button, the source changes
as described on page 7.
AUX INPUT: To select the component
connected to the auxiliary
input jack on the control
panel
LINE INPUT: To select the component
connected to the LINE IN
plug
2
Turn on the connected component
and start playing the source.
• If connecting a JVC's DVD player or VCR,
you can perform the following operations.
auxiliary input