Belkin Wireless G Desktop User Manual page 34

Troubleshooting
If you are using a Belkin 802.11b Wireless Router, the default
name should be "WLAN".
If you are NOT using a Belkin Router, please consult your router
manufacturer's user manual for the default name.
The name of your wireless network appears in
"Available Networks"
If the correct network name is listed in the "Available Networks"
list, please follow the steps below to connect wirelessly:
1.
Click on the correct network name in the "Available Networks" list
to connect to the network.
2.
If the network has security (encryption) enabled, you will need
to enter the network key. For more information regarding
security, see the "Securing your Wi-Fi Network" section of this
User Manual.
3.
Within a few seconds, the tray icon in the lower,
right-hand corner of your screen should turn green, indicating
a successful connection to the network.
If you are still unable to access the Internet after connecting to
the wireless network, please contact Belkin Technical Support.
The name of your wireless network DOES NOT appear in the list
of "Available Networks"
If the correct network name is not listed, check the Service Set
Identifier (SSID) settings to see if they match. The SSID is
case-sensitive and the spelling on each computer must be
exactly the same in order for the Card to connect to the wireless
router (or access point).
Note: To check the SSID settings or look for an available
network, double-click the Signal Indicator icon to bring up the
Belkin Wireless Utility, and then click on the "Configure" tab.
Click on the "Network SSID" box if you do not see the network
to which you are trying to connect, and type in the SSID of the
router (or access point) you are trying to connect. Next, click
"Apply" to save the setting. For more information about setting
up an SSID, please reference your router manufacturer's user
manual. If issues persist even at close range, please contact
Belkin Technical Support.
32 32