Main Burner Ignition & Usage; Methods Of Burner Ignition; Main Burner Ignition; To Extinguish Burner - Weber Spirit E-220 CLASSIC Owner's Manual

METHODS OF BURNER
IGNITION
There are two ways to ignite
burner 1. The first is by
using the Crossover
system built into your grill.
The second is with a match.
Next are the steps for
igniting your grill using the
Crossover ignition system.
®
The following page sets out
steps for igniting your grill
with a match.
20
WWW.WEBER.COM
®
MAIN BURNER IGNITION & USAGE

MAIN BURNER IGNITION

Crossover
The Crossover
spark from the igniter electrode inside the Gas Catcher™
ignition chamber. You generate the energy for the spark
by pushing the igniter button. You will hear the igniter click.
Burner(s) 2 (and 3) can be lit after burner 1 is lit.
ignition
®
A) Open the grill lid (1).
Failure to open the lid before igniting the
grill's burners, or not waiting five minutes
to allow the gas to clear if the grill does
not light, may result in an explosive flare-
up, which can cause serious bodily injury
or death.
B) Make sure ALL burner control knobs are turned
off (2). Check by pushing control knobs in and turning
them clockwise until they stop.
WARNING: The burner control knobs
must be in the off ( ) position before
you turn on the LPG cylinder valve.
C) Turn on the cylinder valve using one of the appropriate
options based on your cylinder and regulator type
Refer to "A)" in "CHECKING FOR GAS LEAKS."
D) Push burner 1 control knob in and turn it anti-
clockwise to start/high ( ) position (3).
IMPORTANT: Always ignite burner 1 first. The other
burner(s) ignite from burner 1.
E) Push in the igniter button several times (4). You will
hear the igniter click.
F) Check that burner 1 is lit by looking through the
cooking grates. You should see a flame.
WARNING: While igniting the grill or
cooking, never lean over open grill.
WARNING: If burner 1 fails to ignite
within five seconds, stop, turn the
burner control knob to off and wait
five minutes to allow the gas to clear
before you try again or light with a
match.
G) After burner 1 is lit, you can turn on burner 2 (and
burner 3).

TO EXTINGUISH BURNER

Push each burner control knob in and turn it clockwise to
the off ( ) position. Turn gas supply off at the source.
Ignition System
®
ignition system ignites burner 1 with a
®
DANGER
1
2
3
4