Advertisement
1. GENERAL FEATURES
Remove the appliance from the packaging. Make sure that no pieces of polystyrene or other
packaging material have been left between one element of the appliance and another.
Check that neither the appliance nor the power cable have been damaged in any way during
transportation.
2. FITTING THE FEET
Remove the feet and the wheels from the polystyrene packing. Turn the radiator upside-down
on a rug or a soft surface in order to prevent damaging the paint finish.
Fit the wheels to the spindles on the feet and push firmly until they click into position. Pull each
wheel to check that it is correctly inserted.
The feet with the casters must be fitted with two arc-shaped brackets only between the 1st and
2nd element (see fig. 1 to 4 inclusive).
3. ELECTRICAL CONNECTION
- Before using the appliance check that your supply voltage is the same of that shown on the
rating label of the unit.
- CONNECT YOUR HEATER TO EARTH PROVIDED SOCKET ONLY.
- This product is manufactured to comply with the radio interference requirements of the
council directive 89/336/EEC.
4. HOW TO USE IT
Switching on
Plug it in; move thermostat to highest setting and switch it on as follows:
a)on-off units with single heat setting:
- key on «I» = ON (pilot light ON, or a mark will appear on the switch)
- key on «O» = OFF (pilot light OFF)
b)units with three heat settings:
- key on «I» = low heat (pilot light ON, or a mark will appear on the switch)
- key on «II» = medium heat (pilot light ON, or a mark will appear on the switch)
- both switches «I» «II» = high heat (both pilot lights ON, or a mark will appear on both switches)
To turn appliance off, switch off both switches or remove plug from wall socket.
Adjusting the thermostat
The switch and thermostat should be maintained until the desired room temperature has been
reached. Now move the thermostat back gradually until the red pilot lamps go out (or until you
hear a 'click). The thermostat can then remain at this setting.
As soon as the room temperature has dropped below the set temperature, the heater switches
itself on automatically until the set temperature has again been reached. In this way the room
temperature remains constant with the most economical use of electricity.
Antifreeze function
Move the thermostat to the
minimum room temperature of approximately 5°C thus preventing freezing with a minimum
energy consumption.
c) Models with a 24 hour time-clock (fig. 5)
To set the heating periods proceed in the following way:
- Set the timer at the correct time. Supposing it is 11.00 a.m. turn the numbered dial of the time-
clock in a clockwise direction until the number 11 coincides with the reference mark
clock. Set the time period during which you wish the appliance to work by pushing the notches
towards the centre. Each notch corresponds to 15 minutes period. At this point sections will
be visible corresponding to the working periods.
position and press the switches. The appliance will maintain a
on the
Advertisement
