Skoda 2012 Superb Owner's Manual page 75

Storing setting
ä
First read and observe the introductory information and safety warn-
ings on page 72.
The memory for the driver's seat provides the option to store the individual posi-
tions of the driver's seat and the external mirrors. A setting position can be allo-
cated to each of the three memory buttons
Storing seat and exterior mirror settings for driving forward
›
Switch on the ignition.
›
Adjust the seat » page 73.
›
Adjust both of the exterior mirrors
›
Press the button » Fig. 56.
A
SET
›
Press one of the memory buttons
ton - an acknowledgement signal confirms that the seat setting is stored.
SET
Storing exterior mirror setting for reversing
›
Switch on the ignition.
›
Press the required memory button
›
Move the rotary knob for the exterior mirror control into position 
›
Engage reverse gear.
›
Move the right exterior mirror into the desired position
›
Take the vehicle out of gear. The set position of the exterior mirror is stored.
Emergency Off
The setting process can be interrupted if necessary, by pressing any button on
the driver's seat.
74
Using the system
Fig. 56
Memory buttons and SET button
» Fig. 56, i.e. three in total.
B
» page 70.
within 10 seconds after pressing the but-
B
.
B
» page
» page 70.
Note
For safety reasons, it is not possible to store this position if the inclination angle
■
of the seat backrest is more than 102° in relation to the seat cushion.
Each new setting stored with the same button erases the previous setting.
■
Each time new seat and exterior mirror settings for forward travel are saved,
■
the individual setting for the right exterior mirror for reverse travel must also be
saved again.
Assigning the remote control key to the memory button
ä
First read and observe the introductory information and safety warn-
ings on page 72.
The remote control key must be assigned to the memory button to be able to re-
trieve the settings that are stored in the memory via the remote control key.
Once the settings for the seat and exterior mirrors are saved
setting, you have 10 seconds to assign the radio remote control to the appropri-
ate memory button.
Assigning the remote control key to the memory button
›
Withdraw the ignition key.
›
Press the button on the remote control key. After the successful assign-

ment, the turn signal lights flash and an audible signal will sound as a confirma-
tion. The setting is stored with the memory button which you have selected.
Assigning the remote control key to the memory button on vehicles with the
KESSY system
›
Switch off the ignition within 10 seconds of storing the setting.
›
Open the driver door.
›
70.
Press the button on the remote control key within 10 seconds.

Note
If the remote control key is assigned to a memory button, which has already
■
been assigned to a radio remote control, the old assignment is replaced by the
new assignment.
If necessary, an additional remote control key can be purchased from a ŠKODA
■
Service Partner. This remote control key can then be assigned to a different mem-
ory button.

» page 74, Storing
