D-Link DPH-140S Installation Manual page 8

SIP PHONE – D-LINK DPH-140S – Installation Guide
2. configure the static IP address on your IP Phone.
Press "MENU", use the cursor to go down and digit the telephone number you have been assigned by Skypho on
the "Display Name:".
Press the "↓" key, it will appear "ADSL DIALUP:", press the " " key to set it on "DISABLE", in the case it is in
"ENABLE" status.
Press the "↓" key, it will appear "DHCP", press " " key to set it on "DISABLE" , in the case it is in "ENABLE"
status.
Press "↓" key, it will appear "IP Address", digit the IP address that you have chosen (ie. 192.168.000.003).
Press the "↓" key, it will appear "Subnet Mask:", digit the network connection data (ie. 255.255.255.0).
Press the "↓" key, it will appear "Voip Router:", digit the default Gateway you will find in the network connection (ie.
192.168.000.001).
Press the "↓", it will appear "DNS Server IP", digit the IP addresses provided by the Internet Service Provider.
Press the "↓" key, it will appear "SNTP Server IP:", insert the IP address 62.94.7.9, press "MENU", then "OK".
Your SIP DPH-140S Telephone is ready to make and receive Voip Calls!
3. to complete the settings, from your PC
open your Web Browser (ie. Internet
Explorer), insert
192.168.0.x:9999
192.168.0.3) and press GO.
4. Leave blank the
"Password" fields and click on "OK".
Look out! ! The confidentiality of this data
is necessary in order to guarantee that the
equipment configuration is accessible only
by you. We suggest to proceed with the
configuration password change and to
write it down by using the "Basic Settings"
menu (Login Web Configuration).
6. After few seconds it will appear the "D-link
DPH-140S Voip Phone" page where you
can modify the configuration parameters of
your D-LINK DPH-140S, as indicate in the
following chapter.
LOOK OUT!: The changes are going to be effective only after the saving ("Update") and restart ("Reboot") of your IP
Phone, as indicated in this manual.
the IP address
(in the example
"Username" and
pag.8