Electrical Set-Up; Control Box Installation - Vector V400 Installation Manual

Electrical Set-up

Electrical Set-up
WARNING
1. Always check that the isolator in the mains supply to the gate is in the OFF position, before doing any
work.
2. Ensure that all low voltage systems (Less than 42.4V) are suitably protected from damage, by
disconnecting all sources of power such as chargers and batteries before doing any work.
3. All electrical work must be carried out according to the requirements of all applicable local electrical
codes. (It is recommended that a licensed electrical contractor perform such work.)
Secure control box to wall
1. Secure the control box to wall using the most
appropriate means.
Be sure to position the wall box so as not to
cause any hazards during and after the
installation.
Preferably mount the wall box:
• Out of direct sunlight
• At a comfortable working height
• Away from garden sprinklers etc.
• To allow easy access even when the
gate is open
Connect all wiring
2. Connect all the cables as required to the
control card. See page 46 and page 47.
3. When wiring each operator back to the
controller housing, it is recommended to
mount a small junction box adjacent each
operator. Terminate the cable provided on the
operator into this junction box and then route a
new cable from the junction box to the
controller housing.
ep 1
For wiring diagram see page 46/47
Page 26