8.
Unlock the operator and swing the gate
closed.
9. Remove the pin and the operator from the
bracket, check that there are at least one or two
turns of the actuator before it is fully extended.
If it becomes obvious that the operator does not
have enough stroke, reduce either the A or B
distances by moving the wall bracket.
Be sure not to make the A and B values less than
allowed for in the installation tables on page 23.
In general:
• Large B distances give good security and
good closing push force.
• Small A and small B will increase the speed.
Fasten gate bracket to gate
10. Secure the gate bracket using the most
appropriate means.
See page 14 for site considerations.
11. Fit operator, wall bracket pins and snap rings.
As an alternative to the snap ring, fit a
padlock.
Page 20
or
or
or