Shutter B L A D E S - Canon Canonet 1 Service Manual

2) A s s e m b l i n g sub s h u t t e r b l a d e
A s s e m b l e a s
shown in the
d i a g r a m ( a ) - ( d ) .
3) A s s e m b l i n g
s h u t t e r b l a d e s
A s s e m b l e a s
(a) - ( e ) .
c l o c k w i s e
d i r e c t i o n .
A s s e m b l e the
l a s t sub b l a d e
on the b l a d e ( e ) .
n . b . P a y a t t e n t i o n not t o put a n y f i n g e r p r i n t s '
on i t .
2 C a s e
Check setting p o s i t i o n of M - G o v e r n o r D r i v e r
switching d o w e l l .
f a r t h e r n e a r to X than M p o s i t i o n .
3 A s s e m b l i n g p l a t e and c a s e
1) Hold the plate with your left hand as shown in the
d i a g r a m , and p r e s s the r e l e a s e l e v e r i n with
your f o r e f i n g e r .
is i n c l i n e d , the a s s e m b l e d b l a d e s c o m e off.
2) Hold it in the d i r e c t i o n which the c a s e is fitted
to the p l a t e , and fit the r e l e a s e l e v e r pin and
long hole for the pin.
12
(e)
t e n s i o n shaft
The p o s i t i o n should be a little
r e l e a s e l e v e r
g o v e r n o r
In this s t a g e pay a t t e n t i o n if it
speed l e v e r