Range-Viewfinder; When The Double- Image Of The Range-Viewfinder Does Not Align; When The Aperture Scale Indicator Inside The Range-Viewfinder Out Of Order - Canon Canonet 1 Service Manual

RANGE-VIEWFINDER

When the double-image of the Range-Viewfinder does not align, it should be adjusted in the following manner:
Turn Screw C4221 when the
Turn the Eccentric Screw of Lever C9285 to right or l e f t when the
Care must be taken not to turn C4221 and the Eccentric Screw of C9285 too far as the screw thread may
become worn or its calking may become loosened.
Cover Plate C9252 need not be removed when adjusting the double-image.
Eccentric Screw of C9285
When the Finder Mask does not move smoothly even after turning the Focusing Ring, the following adjustments
should be made.
1. Check to see if Spring C4216 has become weak.
it w i t h a new one.
2. When the pressure of Holder C4179 is too strong, bend C4179 to weaken it.
3. When Viewfinder Mask C9430 is touching Cover Plate C9252, make the proper corrections by bending C9252.
4. If Viewfinder Mask C9430 is touching Aperture Scale Index C9429 or EE-Signal C4359, bend either C9429
or C4359 so that there will be a gap of approximately 1 m m .
When the Aperture Scale Indicator inside the Range-Viewfinder out of order, the following ajustments should be
made:
1. Make necessary adjustments by turning the Eccentric Screw of Lever C9427.
needle should again become unaligned, it means that the calking of the Eccentric Screw has become loose.
In this case, replace C9427.
2. If -the needle of Aperture Scale Index C9429 is bent and is touching Viewfinder Mask C9430, adjust by
bending the needle.
deviation of the double-image is vertical.
If so, bend C4216 to give it more strength, or replace
4
deviation of the double-image is horizontal.
See Repair Manual p.3.
'C4221
See Repair Manual p.3.
See Repair Manual p.3.
See Repair Manual pp. I S3.
See Repair Manual pp.2&3.
If after adjustment the
See Repair Manual p.2.
See Repoir Manuol p.3.