Canon Canonet 1 Service Manual page 51

3) P l a c i n g the c a s e and the plate in p a r a l l e l ,
a s s e m b l e in until the height of r e l e a s e p i n ' s top
end b e c o m e s s a m e l e v e l as the oblique l i n e s
p o r t i o n of the d i a g r a m .
w o r k (a) and (b)
r e l e a s e pin
4 ) A s s e m b l e s y n c h r o side
tightly
w o r k (c)
5) Being s y n c h r o side
c l o s e l y fitted t o . . . .
w o r k (d)
6) A s s e m b l e the o t h e r
side ( s y n c h r o w i r e s i d e . )
In this s t a g e a s s e m b l e after
M - G o v e r n o r D r i v e r i s
p r o p e r l y s e t .
w o r k (e)
4 F a s t e n four p i e c e s of s c r e w for the p l a t e .
Refer to the i t e m how to d i s a s s e m b l e (3)
of this s e c t i o n .
5 Hanging s p r i n g for s y n c h r o c o n t a c t .
Refer to the i t e m how to d i s a s s e m b l e (1)
of this s e c t i o n .
6 Fixing t e n s i o n l e v e r
Put a little lac to s c r e w hole of t e n s i o n shaft.
n . b . 1 P u t c o r r e c t l y the p i e c e s of w a s h e r which
have b e e n i n s e r t e d .
2 P a y attention that l a c
should not be put to
the o p e r a t i o n p o r t i o n .
13
h c a s e
4 plate
5 >
~ \
(e) [