Chamberlain Elite EL25 Installation Manual page 19

Wiring Power to the EL25 (con't)
Power Wire Specifications and Run Distances
Distance
Under 30 Feet
30 - 75 Feet
75 - 250 Feet
Caution: Not responsible for conflicts between the information listed in the above table and the requirements of your local
building codes. The information is for suggested use only. Check your local codes before installation.
Powering Up and Checking the LEDs
Plug the transformer into the 110 VAC outlet. Check the SYS PWR LEDs on the Main board.
ON – Board has Power.
LED
LO – Power is Too Low.
LED
HI – Power is Too High.
LED
LO HI
If the or LEDs are lit,
press the PWR MON RST
(Power Monitor Reset) button.
If the LO or HI LED is still lit,
check the power connections,
wiring, and transformer.
12 VAC Power (Included)
2 -Conductor Shielded
ON
PWR MON RST
Page 18
14 AWG
14 AWG
14 AWG
J406
J402 J402 J200 J200
HI LO
12 VDC Power
(Not Provided)
2 -Conductor Shielded
16 AWG
14 AWG
N/A
J201
Hard Reboot