Mounting The System In A Distribution Rack - 3Com SuperStack II Switch 9300 Getting Started Manual

Mounting the System in a Distribution Rack

To mount the system into a distribution rack:
Carefully lift the system into place and align the
1
appropriate holes in the mounting brackets with the
designated holes in the distribution rack.
Figure 9 Aligning Bracket and Distribution Rack Holes
Hole
#1
Hole
#3
3U
(5.25")
Hole
#6
Hole
#8
Have another person hold the system in place. Insert
2
the four suitable mounting screws (not provided) into
the designated mounting holes on the bracket.
Repeat for the other side.
Verify that the system is level.
3
Switch 9300
(Position 1)
1000 Base - LX 1000 Base - SX
TX 1 RX TX 2 RX TX 3 RX
TX 4 RX TX 5 RX TX 6 RX
1000 Base - LX 1000 Base - SX
TX 1 RX TX 2 RX TX 3 RX
TX 4 RX TX 5 RX TX 6 RX
Switch 9300
(Position 2)
Tighten the mounting screws. The system is now
4
installed in the distribution rack.
Figure 10 shows two Switch 9300 systems installed in
a distribution rack.
Figure 10 Two Systems Installed in a Rack
TX 7 R
TX 7 R
You are now ready to cable the system. For cabling
instructions, see Chapter 3.
Installing the System in a Distribution Rack 23