Installation Instructions; Connecting To The Power Supply; Filling The Water Tank - STARBUCKS Sirena User Manual

4 INSTALLATION
For your own safety and that of other people, please strictly follow the "Safety Regulations" in section 3.
4.1 Packaging
The original packaging has been designed to protect the machine during transport.
It is recommended to keep the packaging for future transport.

4.2 Installation instructions

Before installing the machine, observe the following safety precautions:
• Place the machine in a safe area: on a flat, stable surface, away from water and moisture;
• Make sure the machine is out of the reach of children;
• Avoid placing the machine on very hot surfaces or near open flames.
The espresso machine is now ready to be connected to the power supply.

4.3 Connecting to the power supply

Before turning on the machine, make sure that the hot water / steam knob is closed.
• Electric current can be dangerous! Therefore, it is essential to follow the safety regulations carefully.
• Never use faulty electrical cords! Faulty electrical cords and plugs must be replaced immediately by
authorized Customer Service Centers.
• The voltage of the appliance has been set by the manufacturer.
• Check that the voltage supplied matches the indications on the label on the bottom of the appliance.
• Connect the power cord to the machine as shown in Figure F.
• Connect the plug end of the power cord to a socket with suitable voltage.
• You can preheat your cups by placing them on the cup warming tray. (Warm cups will help retain the
espresso's crema and aroma.)
NOTE: The machine is equipped with an energy saving system. The machine will automatically
shut off 90 minutes after its last operation. To turn the machine on, press the power button (15).

4.4 Filling the water tank

• Lift and remove the water tank lid (7).
• Remove the water tank (8) using the handle provided on the inside.
• Rinse and fill it with filtered water, taking care not to overfill.
• Replace the tank; press down firmly. Replace the lid (7).
For best results, only use cold, filtered water to fill the tank. Never use sparkling water. The quality and
filtration of the water to fill the tank will affect the final flavor of the espresso.
Hot water or any other liquid may damage the tank. Do not turn on the machine without water in the
tank; always make sure there is enough water in the tank.