Advertisement
Installation
The following illustration shows a typical installation. If you are not sure how to install this unit correctly, contact your JVC car audio dealer or a company supplying kits.
In-dash mounting
When installing the unit without using the sleeve
In a Toyota car for example, first remove the car radio and install the unit in its place.
Pocket
Bracket *
2
Electrical connections
Make sure to disconnect the battery's negative terminal.
• Be sure to ground this unit to the car's chassis again after installation.
Note:
It is recommended to connect to the speakers with maximum power of more than 50 W (both at the rear and at the front, with an impedance of 4 Ω to 8 Ω). If the
maximum power is less than 50 W, change "AMP GAIN" setting to prevent the speakers from being damaged (see "Menu operations" on page 3).
Typical connections
IMPORTANT: A custom wiring harness (separately purchased) which is suitable for your car is
recommended for connection between the unit and your car.
• Consult your JVC car audio dealer or a company supplying kits for details.
Antenna terminal
Rear line out
Rear ground terminal
Connect only the front speakers
if your speaker system is two-
speaker system.
White with black stripe
Front speaker
White
(left)
Gray with black stripe
Front speaker
Gray
(right)
Green with black stripe
Rear speaker
Green
(left)
Purple with black stripe
Rear speaker
Purple
(right)
8 mm (3/8")
Flat head screws—M5 × 8 mm (3/8") *
2
15 A fuse
Black
To the metallic body
or chassis of the car
To a live terminal in the
fuse block connecting
Yellow *
3
to the car battery
(bypassing the ignition
switch) (constant 12 V)
Fuse block
To an accessory
Red
terminal in the fuse
block
Blue with white
To the remote lead of other
stripe
equipment or automatic
antenna if any (200 mA max.)
Removing the unit
Release the rear section first...
Connecting the external amplifier or subwoofer
Set "L/O MODE" to "REAR"
(See "Menu operations" on page 3.)
You can connect a power amplifier for
rear speakers.
Rear
JVC Amplifier
speakers
Set "L/O MODE" to "SUB.W"
(See "Menu operations" on page 3.)
Ignition
You can also connect a subwoofer to
switch
the REAR LINE OUT terminals.
JVC Amplifier
Subwoofer
PRECAUTIONS on power supply and speaker connections
*
1
When you stand the unit, be careful not to damage the fuse on the rear.
2
*
Not supplied for this unit.
3
*
Before checking the operation of this unit prior to installation, this lead must be connected, otherwise the power
cannot be turned on.
*
4
Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place uncoated with
paint (if coated with paint, remove the paint before attaching the wire). Failure to do so may cause damage to
the unit.
6 – EN
See "Electrical connections" below.
High
Heat sink
Remote lead
Y-connector *
Remote lead (blue with white stripe)
To the remote lead of other
equipment or automatic
antenna if any
Signal cord *
2
Front speakers
or
2
Advertisement
