Changing The Information Display; Timer And Sleep Operation; (Remote Control Only) - Sharp XL-DAB10NH Operation Manual

Changing the information display

You can switch DAB+ display information.
Press the DAB DISPLAY button.
Each time the button is pressed, the information display
changes in the following order.
When "NO SERV" appears, the DAB DISPLAY button
does not allow you to change the display.
[Station Name]
[Signal quality]
[Mode]
[Channel/Frequency]
[Station Name]
Station name is displayed. (set by default)
[Scrolling text]
Information scrolls across the display when sent from the
station.
[Programme type]
A description of the type of content being broadcast by
the station.
[Multiplex name]
The name of the multiplex (ensemble) which provides the
current service.
[Channel/Frequency]
The DAB+ channel and frequency for the station.
(Frequency is displayed to two decimal places)
[Mode]
The data transfer speed and channel type (stereo or
mono) appear.
[Signal quality]
The signal quality is displayed as a number (0 - 100).
[85-100: Good, 70-84: Fair, 0-69: Poor]
Timer and sleep operation (Remote
control only)
[Scrolling text]
Timer playback:
The unit turns on and plays the desired source (CD,
[Programme type]
TUNER, USB, iPod) at a preset time.
■ Timer playback
Before setting timer:
[Multiplex name]
1
2
1
2
3
4
5
6
E-19
Check that the clock is set to the correct time (refer to
page 6).
If it is not set, you cannot use the timer function.
For timer playback, load the disc to be played back.
Press the ON/STAND-BY button to turn the power on.
Press the CLOCK/TIMER button for about 2 seconds.
Within 10 seconds, press the CLOCK/TIMER button.
Press the or button to set hour then press the
CLOCK/TIMER button.
Press the or button to set minute and then
press the CLOCK/TIMER button.
Switch input with the or
OFF" and then press the CLOCK/TIMER button.
button to select "TMR-