Setting The Clock (Remote Control Only) - Sharp XL-DAB10NH Operation Manual

General control (continued)
■ Function (on main unit only)
When the FUNCTION button on main unit is pressed, the
current function will change to different mode. Press the
FUNCTION button repeatedly to select desired function.
CD
AUX IN
Note:
The backup function will protect the memorised function
mode for a few hours should there be a power failure or the
AC power lead becomes disconnected.
■ Equaliser
When the EQUALIZER button is pressed, the current
mode setting will be displayed. To change to a different
mode, press the EQUALIZER button repeatedly until the
desired sound mode appears.
FLAT
ROCK
CLASSIC
POPS
VOCAL
JAZZ
TUNER DAB
iPod USB
No equalisation.
No equalization.
For rock music.
For rock music.
For classical music. For classical music.
For pop music.
For pop music.
Vocals are enhanced.
Vocals are enhanced.
For jazz.
For jazz.
Setting the clock (Remote control
only)
In this example, the clock is set for the 24-hour (00:00)
display.
1
Press the ON/STAND-BY button to turn to stand-by
mode.
2
Press and hold the CLOCK/TIMER button until "00:00"
appear.
3
Within 10 seconds, press the
adjust the hour and then press the CLOCK/TIMER
button. Press the
the time by 1 hour. Hold it down to advance
continuously.
4
Press the or
then press the CLOCK/TIMER button. Press the
button once to advance the time by 1 minute. Hold
it down to advance continuously.
To confirm the time display:
[When the unit is in the stand-by mode]
Press the CLOCK/TIMER button. The time display will
appear for about 5 seconds.
[When the power is on]
Press the CLOCK/TIMER button. The time display will
appear for about 5 seconds.
Note:
The "00:00" will appear blinking when the AC power supply
is restored after a power failure or unplugging the unit.
Readjust the clock as follows.
To readjust the clock:
Perform "Setting the clock" from step 1.
E-6
or button to
or button once to advance
button to adjust the minutes and
or