Coffee Now; Coffee Later - Using The Timer - Russell Hobbs 10968S Instructions Manual

· Close the lid on the water tank.
· Put the carafe on the hotplate, you'll feel some resistance as the non-drip valve is pushed up.
Make sure it is in the correct position, as coffee will not flow correctly if not aligned.
· Alternatively, turn the water tank clockwise to unlock it from the coffee maker body; lift it off
the machine; lift its lid, fill it with cool water and close the lid. Don't fill above 'max' level on the
water tank.
· Align the slot in the water tank with the latch, then lower it and turn anti-clockwise to clockwise
to lock.
· Pull the tab to swing the basket out(towards the water tank).This will expose the filter.
· Place the desired amount of ground coffee into the filter basket. Measure one level tablespoon
of ground coffee for each cup of coffee desired. For stronger or milder coffee, adjust amount of
coffee to suit your own taste.
· Once you have put the desired amount of coffee in the filter, swing the basket back into place.
Important: Be sure not to over-fill the filter with too much coffee. Use only fresh cool water.
NOTE: We recommend using fresh top quality ground coffee specifically for automatic filter
coffee makers.
TIP: Experiment to learn how much ground coffee to use for the strength of coffee you prefer.
Tastes vary and there are no hard and fast rules.
NOTE: Use only cold water-the Russell Hobbs automatic brewing system has been designed to
work only with cold water.
TIP: The amount of brewed coffee will always be less than the amount of water placed into the
coffee maker, since about 10% is absorbed by the coffee granules and filter.
· Insert the power cord into a 230-240V AC power outlet and turn the power on. The clock will
flash 12:00.

COFFEE NOW

· Ignore the clock.
· Press the button, the brewing light will come on and shortly afterwards, coffee will drip
into the carafe.
COFFEE LATER-USING THE TIMER
NB If you overshoot, you can't go back. Go right round, or unplug to reset the display to
12:00.Hold the buttons down to fast forward.
· To set the clock press the 'h' and 'min' buttons-the pm light will come on when you pass
noon.
· Set the timer the same way, with the button pressed.
· Release the button and press the auto button to activate the timer, the auto light will come
on.
pm
light clock display
12:00
○ ○
auto
○ ○ ○