Using Automatic Gain Mode - AKG PT4500 User Instructions

The display will change as follows:
• To save the new setting, push the setup switch briefly.
The display will show your new gain setting in dB and the "GAIN" label will be flash-
ing.
• If you'd rather not save your setting, turn the setup switch briefly to the left or right.
The display will change to "SAVE-N".
- Push the setup switch briefly. The display will revert to the original setting, with the
"GAIN" label flashing.
3. To set input gain again, repeat steps 1 and 2 above.
4. To return to LOCK mode, push and hold the setup switch for approx. 1.5 seconds.
1. From the Gain menu, turn the setup switch to the left and hold until the display changes
as follows:
2. Push the setup switch briefly.
The message ">tESt<" will start flashing on the display.
3. Talk or sing into the microphone as loud as you can.
The transmitter will automatically set the optimum input gain.
The display indicates the audio level by short lines. The peak level is indicated by a heav-
ier line that will remain fixed for approx. 2 seconds.
4. Push the setup switch briefly.
The display will show "SAVE >-Y<".
• To save the new setting, push the setup switch briefly.
The display will show your new gain setting in dB and the "GAIN" label will be flash-
ing.
• If you'd rather not save your setting, turn the setup switch briefly to the left or right.
The display will change to "SAVE >-N<".
- Push the setup switch briefly. The display will revert to your original setting, with the
"GAIN" label flashing.
5. To set input gain again, repeat steps 1 through 4 above.
6. To return to LOCK mode, push and hold the setup switch for approx. two seconds.
PT 4500
3 Setting Up
3.8.2 Using
Automatic Gain Mode
31