Replacing The Light Bulbs - Monogram Side-by-SideStainless SteelFree-StandingRefrigerators Owner's Manual

Fresh food
upper light
Fresh food
lower light
Freezer
compartment
Dispenser
22
Setting the controls to OFF does not remove
power to the light circuit.
1 Unplug the refrigerator.
2 The bulbs are located at the top of the
compartment, inside the light shield.
On some models, a screw at the front
of the light shield will have to be removed.
3 To remove the light shield, press in on the tabs
on the sides of the shield and slide forward and
out.
Setting the controls to OFF does not remove
power to the light circuit.
This light is located above the top pan.
1 Unplug the refrigerator.
2 Remove the convertible meat drawer control
knob by pulling straight out.
3 Lift the light shield up and pull it out.
4 After replacing the bulb with an appliance
bulb of the same or lower wattage, replace the
shield and the knob.
5 Plug the refrigerator back in.
Setting the controls to OFF does not remove
power to the light circuit.
1 Unplug the refrigerator.
2 Remove the shelf just above the light shield.
(The shelf will be easier to remove if it is
emptied first.) On some models, a screw at the
top of the light shield will need to be removed.
3 To remove the light shield, press in on the sides,
and lift up and out.
Setting the controls to OFF does not remove
power to the light circuit.
1 Unplug the refrigerator.
2 The bulb is located on the dispenser under
the control panel. Remove the light bulb by
turning it counterclockwise.

Replacing the Light Bulbs

Stainless Steel Refrigerator
4 After replacing the bulb with an appliance bulb
of the same or lower wattage, replace
the light shield and screws (on some models).
When replacing the light shield, make sure that
the tabs at the back of the shield fit into the slots
at the back of the light shield housing.
5 Plug the refrigerator back in.
4 Replace the bulb with an appliance bulb of the
same or lower wattage, and reinstall the light
shield. When reinstalling the light shield, make
sure the top tabs snap securely into place.
Replace the screw (on some models).
5 Reinstall the shelf and plug the refrigerator
back in.
3 Replace the bulb with a bulb of the same size
and wattage.
4 Plug the refrigerator back in.
Tabs